JINYINGUHF Passive RFID Long Range Card Readerfactory default support WG26/WG34,RS232/RS485,it available customized WiFi function..Here listed TCP/IP ( Ethernet ) Configuration for your check:
Open “RFIDDemo.exe” in Document of “RFIDDemo”;
Connect to the LAN port of Computer or Router;
To power up the reader, then you can configuration the TCP/IP of reader;
Running NET Config Software diagram
1.Open “RFIDDemo.exe”:
2.Choice “Net Interface”, click “BROADCAST” of the menu;
3.Broadcast the TCP/IP Address of Reader:
4.Get the TCP/IP Parameters of reader:
5.Set the TCP/IP Parameters of reader:
6.Wait about 5~15sec, click “Broadcast”, Broadcast the TCP/IP Address of Reader to confirm;
7.At the step, the configuration is complete;